QNAP REXP-1600U-RP Bedienungsanleitung

QNAP RAID Expansion Enclosure Hardware User Manual © 2012. QNAP Systems, Inc. All Rights Reserved.

10 Storage expansion card (optional purchase) 1 Table 1: Package Contents

11 2. Hardware Specification The physical specifications, operating environment, and power requirements of the RAID expansion enclosure are listed

12 Power Supply Input: 100-240V AC, 50-60Hz; Output: 600W COM port Reserved for system maintenance Fan 3 x 6 cm smart cooling fan Management (via NAS

13 3. RAID Expansion Enclosure Hardware Illustration Caution: Modifying the hardware, software, or firmware of the QNAP products will void the w

14 2 Hard Drive LEDs 3 Tray Lock 4 Release Button 5 Hard Drive Tray Caution:  Always turn on the RAID expansion enclosure before turning on th

15 LED Color State Description System Status Green Green The system is ready Flash green The system is starting up Off The system is off System Fa

16 3.2. Rear view REXP-1200U-RP REXP-1600U-RP 1 COM Port (Reserved) 2 IN Port 3 IN/OUT Port Status LED 4 OUT Port 5 Power Switch 6 Enclosure

17 LED Color State Description Link Status Green Green Port linked Flash green Data is being transmitted Off No link activity Link Fault Amber Amber

18 4. Cable the System 4.1. Cabling Instructions An example of connecting a QNAP NAS to four REXP-1200U-RP enclosures is shown below. 1 Conn

19 4.2. Mini SAS Cable Removal Follow the steps below to remove the Mini SAS cable. 1. Pull up the restraining clip latch of the Mini SAS cable.

2 Thank you for choosing QNAP products! This user manual provides description of the hardware of the QNAP RAID expansion enclosure and relevant guid

20 5. Remove an Air Duct (Applied to REXP-1600U-RP) Unlatch the air duct with your thumb and index finger. Pull the air duct upward to disengag

21 6. Install/Remove a Fan Module 6.1. Install a Fan Module Insert a fan module into the fan slot until the fan module is fully seated. Warnin

22 7. Install Power Supply Unit Warning: The RAID expansion enclosure supports replacing the redundant power supply unit without turning off the e

23 3. Unplug the failed power supply. 4. Plug in a new power supply. 5. Turn on the RAID expansion enclosure.

24 Technical Support QNAP provides dedicated online support and customer service via instant messenger. Online Support: http://www.qnap.com MSN

3 DISCLAIMER In no event shall the liability of QNAP Systems, Inc. (QNAP) exceed the price paid for the product from direct, indirect, special, in

4 Regulatory Notice FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to P

5 Symbols in this document Warning This icon indicates the instructions must be strictly followed. Failure to do so could result in injury to huma

6 Contents CONTENTS ...

7 Safety Warnings 1. The RAID expansion enclosure can operate normally in the temperature of 0ºC–40ºC and relative humidity of 0%–60%. Please make

8 Warning:  Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.

9 Before You Start 1. The RAID expansion enclosures can ONLY be used with the QNAP Turbo NAS. 2. Install the hard drives in sequential order foll